Posts getting cut off.

[Darren]

Thank you for your messages. I will notify the IT department and see if we can find out what may be going on. It could be a problem with cache settings on an individual's computer.

-Darren Marin
Family Tree DNA

[rucksack]

OK, it let me post here, but not where I was trying to post... a response to PDHOTLEN in a U5 forum.

[rucksack]

It won't allow me to post at all.

Let's see if it allows a posting here.

[Yaffa]

Forum glitch

Darren,

There seems to be a glitch in the forum somewhere. The Computer administartor of these boards is telling a few of us we can't post more than one message with in in 30 seconds. This happens when I have not posted at all and just go to post a message. This happened to me twice in the past 2 days. Others have told me the same thing happened to them.

Thanks

[girlperson1]

If you continue receiving problems email me what you would like posted and I should be able to get it to work. Let me know where you want it posted. You can email me through the contact us link found at the bottom of the page.

-Darren Marin
Family Tree DNA

Thanks very much!

[Darren]

If you continue receiving problems email me what you would like posted and I should be able to get it to work. Let me know where you want it posted. You can email me through the contact us link found at the bottom of the page.

-Darren Marin
Family Tree DNA

[girlperson1]

What about those of us who type the entire message into THIS window? I did that with my posts and even suspected it had something to do with punctuation but alas, try as I may, nothing seemed to work.

[Darren]

Hello Everyone,

Darren here with Family Tree DNA. I have seen several posts that have been cut off prematurely and this is likely caused by punctuation that the system is failing to accept properly, so it deletes everything after it. I have seen this happen with:

'

"

and

...

If you are creating a document in word I am not sure if saving it as a plain text or rich text format might work, but if you paste text from word into the thread text window, be aware that you may need to delete these characters and then re-enter them. For example if you have a word document that says I'm R1b1b2, you will likely need to delete the apostrophe and type it again once the text has been pasted into the edit message window for the forum. I am not aware of this issue happening when you type the text directly into the thread text window as opposed to copying and pasting.